Static editor · Composition · 3 min read
Use guides and grids
Lay the rule of thirds, a safe area, columns and rulers over your mockup in the Static mockup editor, then turn the overlays off in one click.
In the ls.graphics Static mockup editor, the ruler button at the top-left of the canvas opens the Guides card: Thirds, Golden, Center, Diagonals and Safe area overlays on ⌥1–⌥5, a Show rulers switch on ⇧R, and Add layout guide for a Grid, Columns or Rows. Switch them on to place your design, then reset them in one click.
The guides are drawn over the picture on the canvas, so they help you check where the device and your design sit in the frame. In our test we used a Studio Display scene with our own design on the screen; to put yours on a mockup first, see Create a mockup online. The same card works in 3d Studio: Use guides and grids in 3d Studio.
Watch guides and grids on a Studio Display
Thirds, a safe area, five columns with a 200 px gutter and the rulers over a Studio Display mockup, then one click on the reset.
Transcript
Click the ruler button at the top-left of the canvas. The Guides card opens.
Click Thirds. Two vertical and two horizontal lines split the picture into nine parts.
Click Safe area. A frame appears inside the edges of the picture.
Drag the right edge of the safe area inward. An orange badge shows the margin, and all four edges move together.
Click Add layout guide. A Grid 10px guide is added and a fine grid covers the picture.
Open its menu and choose Columns. The guide becomes Column 5.
Click the Gutter field and type 200. Five wide column bands cover the picture.
Click Show rulers. Rulers appear along the top and left of the canvas.
Click the reset button next to the card’s title. Thirds and Safe area turn off; the column guide and the rulers stay.
Open the Guides card
Click the ruler button at the top-left of the canvas, next to the Fill the canvas button. The Guides card opens with five rows, the Show rulers switch and the Add layout guide button. Each row shows its key on the right.
Turn on the rule of thirds
Click Thirds. Two vertical and two horizontal lines split the picture into nine equal parts, and the row is highlighted. A reset button appears next to the Guides title as soon as one row is on.
Drag the safe area
Click Safe area. A frame appears inside the edges of the picture. Drag any of its lines on the canvas: the margin changes on all four sides at once, and an orange badge shows it while you drag.
In our test, dragging the right edge 60 screen pixels inward moved all four edges by 60, and the badge read 621: the margin in pixels of the picture.
Add a column layout guide
Click Add layout guide. A new guide appears under the button as Grid 10px, with an eye button and a minus button, and a fine 10 px grid covers the picture. Open its menu and choose Columns.
The guide now reads Column 5, with Count 5, Gutter 20 and Margin 0. On a large Static picture a 20 px gutter is thin, so type a bigger value: with Gutter 200 the five column bands are easy to see.
Show the rulers
Turn on Show rulers. Rulers appear along the top and left of the canvas, counted in pixels of the picture, and the canvas shrinks a little to make room for them.
Reset the guides
Click the reset button next to the Guides title. Every row from Thirds to Safe area turns off and the reset button disappears. The column guide and the rulers stay: remove a layout guide with its minus button, hide it with the eye, and close the card with ×.
Once the picture is lined up, change its shape with Change canvas aspect ratio and check the guides again.
Result: in our test on a Studio Display scene, Thirds, Safe area, five columns with a 200 px gutter and the rulers were on together, and one click on the reset turned the five rows off while the columns and rulers stayed.


